The plug for 56K frame relays differs slightly from the T1 or 128K+. Use the internal screws to connect your cable in the following manner:Ī commonly used Network Interface Device (NID) by HyperEdge - pinout diagram w. When opening the biscuit, there are 8 color coded wires. It isn't necessary that it be shielded.Īn RJ48S biscuit is frequently used to terminate a data circuit. A twisted-pair ethernet cord will also work, and is better for anything over a few feet. Make sure that the pins are not reversed, looking through the clear plugs you should see the colored wires in the same left-to-right order on both ends. For short runs, flat ribbon cable is fine, and one about 6 feet is normally supplied with the CSU. The cable from the telco demarc (punch-down block) to the CSU/DSU is just a plain straight-through 8-conductor modular cable with a RJ-48 or RJ-45 plug at the end. One end T568A, other end T568B (Crossover Cable). Hub to Hub or Computer to Computer connection:
0 Comments
Leave a Reply. |